SAMSUNG SyncMaster Monitor User's Manual

Model

Connecting Cables

Connect the power cord for your monitor to the POWER port on the back of the monitor.
Plug the power cord for the monitor into a nearby outlet.

Use appropriate connection for your computer.

	Using the RGB (Analog) connector on the video card. - Connect the signal cable to the 15-pin, RGB IN port on the back of your monitor. [ RGB IN ]
	Using the DVI (Digital) connector on the video card. - Connect the DVI cable to the DVI IN(HDCP) port on the back of your monitor. [ DVI IN(HDCP) ]
	Connected to a Macintosh. Connect the monitor to the Macintosh computer using the RGB connection cable.

If the monitor and the computer are connected, you can turn them on and use them.

Connecting a Speaker

	When connecting a speaker, be careful that the grooves of the monitor and the speaker . ()are aligned with each other. Adjust the aligned positions until you hear a ‘click’. If a speaker is connected correctly, you can hear a ‘click’.If a speaker is connected without you hearing a ‘click’, the holding part may become damaged.
	If you need to separate, please pull () a little and push to the right.

MIC / SPK

	Connect the red cable of the cables provided when the speaker was purchased to the audio output terminal at the back of the computer. Connect the other end of the cable to the red terminal at the back of the speaker.

	Connect the light green cable of the cables provided when purchasing the speaker to the audio output terminal at the back of the computer. Connect the other end of the cable to the light green terminal at the back of the speaker.

	Connect a headphone to the black terminal at the right of the speaker.

	Connect a microphone to the red terminal at the right of the speaker.

By turning part ( + , - ) in the direction shown in the figure below, the speaker turns on and the volume increases.

Connect the power line connected to the speaker to the black terminal of the monitor.
This speaker is not connected to an external power source. It is connected to a monitor for the required power.

Using the Stand

Sliding stand

Stand Stopper

Swivel stand

	Using (),You can swivel the monitor left and right at an angle of 90° to set the monitor lengthwise. The rubber under the stand is to avoid the monitor slide.
	When you try to rotate the monitor in the state of the power cord or cable connecting to the monitor, the power cord of cable can be destroyed.

Tilt angle

Using (), You can adjust the tilt anlgle within a range of 3° forward to 25° backward for the most comfortable viewing angle.

Attaching a Base

This monitor accepts a 200 mm x 100 mm VESA-compliant Mounting interface pad.

	Monitor

	Mounting interface pad (Sold separately)

1.	Turn off your monitor and unplug its power cord.
2.	Lay the LCD monitor face-down on a flat surface with a cushion beneath it to protect the screen.
3.	Remove four screws and then remove the stand from the LCD monitor.
4.	Align the mounting interface Pad with the holes in the rear cover mounting pad and secure it with four screws that came with the arm-type base, wall mount hanger or other base.

To mount the monitor on a wall, you should purchase the wall mounting kit that allows you to mount the monitor at least 10 cm away from the wall surface.
Contact the nearest Samsung Service Center for more information.
Samsung Electronics will not be responsible for damages caused by using a base other than those specified.
Please use Wall Mount according to the International standards.